Editing a Backbone Fabric
To edit a configured backbone fabric from the Fibre Channel Routing Management window, follow the instructions below:
1. Click the Settings icon ( 
), and then select > .
), and then select > .2. Click down arrow icon ( 
) on an existing backbone and then select View.
) on an existing backbone and then select View.
3. Click Add to add a new port.
4. For configuring and removing ports from the backbone fabric, perform the following steps:
a. Click down arrow icon ( ) on a port and select Configure or Remove.
) on a port and select Configure or Remove.You can select multiple ports and click Configure to edit the port properties or Remove to reset the specific EX-ports.
You can also enable or disable the ports in the Configure window.
b. Click OK to confirm the changes.
5. Click Save to overwrite the changes.
◦ Click Cancel to discard the changes.
◦ Click Delete to delete the configured backbone fabric.
When you click delete SANnav disables the EX_Ports and changes the EX_Ports to normal port. Also, SANnav disables the Fibre Channel Routing service but retains the configured Backbone Fabric ID.
Note: There is no provision to configure the Translate domain.
It will take some time to reflect the changes in the Fibre Channel Routing Management window.
You can view the progress in the Events tab.
Parent topic